pretty sure those are closer to a "double 60" than 45

Yeah, I can't cut that one either. Strictly double 45 here. BTW what is that tool, it seems useful. Where can I get one like that?

I guess I'll be the one to say it - it would be better (wiser) to buy more bits than to buy that tool you are inquiring about. Bits are as low as $6 each, shipped.

Its not a bit problem, my router is permanently attached to the table, I'd have to destroy the table to change the bit. So I'm stuck with double 45 until the bit wears out. Then I'll have to get both a table and a bit.

Oh - well that's simple - yer just gonna have to hold that there shell at about a 15 degree angle (or somethin like dat)!

If you can ever get your hands on a router (handheld - no table) which would allow for other bits - check this out - grabbed this off of DFO (if I recall correctly):

Yo.

I am actually quite impatient and sloppy in my work, but I still got a really really good result!

Im not sure what a bearing guided router cutter is, I just use a 45 degree blade, actually I think it's 90 degrees, but you get a 45 degree cut. Anyway, after some experimentation and a few ruined cheapy drums, I now have it adjusted to where I get a beautiful 45 degree cut of just the perfect size. I'm very happy with it, and loathe to change it. This setting is too hard won to mess around with.

its a profile gauge... the better ones have more pins and are made of metal, but that one was about $18 Cdn

usually found at most hardware stores, or any Lee Valley

have you seen the bearing edge in question yet? Being the reso side of the BD you might get away without touching it

haven't examined it yet, but I was thinking/hoping the same. Going to need to get a hoop, claws and t-rods too.

Great drum kit! I have a Yamaha kit in the same finish. Mine is a 5 piece with the chrome metal snare with it instead of the matching wood snare. If you ever decide to sell the snare, let me know.