Thanks..This is after 2 coats of rub-on gloss polyurethane. It may need two more coats.
The paper-backed veneer is quite easy to work with. I cut it with scissors about 1/4" extra wide then trimmed at an angle to the bearing edge to make it clean at the bearing edge. I used 3M spray on adhesive on both surfaces. The veneer is only 10 mil thick so, it won't interfere with drum head fit.
I'll post a pic of the the unfinished veneer sheet.
Question? I"m trying to decide whether ot not to leave the tom and bass "virgin". Any thoughts??
~K