Ok, I'm going to be wrapping a 3-ply Ludwig kit.
There are spots of missing ply, a couple of good sized extra holes, as well as glue residue on the shells. I am going to use dowels for the holes and filler for the missing chunks of ply. I want to figure out what in which order to proceed.
I had planned on using a stripper to remove the gule first, but will that damage the Poplar middle ply that is exposed?
Or, should I use the filler first and then use the stripper? (Will the filler still be OK?) and then sand?
Or, should I use the filler, forget the stripper and just sand everything smooth, hoping all of the glue will be gone after I'm done.
I am going to be using the 3M glue for the wrap.
Thanks in advance for your replies!