Hi,I have a Holiday tom with rounded bearing edges,drilled for the peanut lugs. I attempted to mount the swivo oval plate and only the left/right holes lined up. The top/bottom holes are real close but,no cigar lol. I could enlarge the top/bottom holes or,just go with the two.
My real question is has anyone encountered this before? Did Rogers change the size of the mount over time? Thanks
Had the same question a while back. Rogers did make a slight change from the original Cleveland hole spacing. It is slightly longer spacing then later pieces. You can see that the screw heads go to the edge, while later models have some space at the edge. The correct pieces are out there. Just makie sure that you have someone measure VERY accurately. Don't remember the difference, but it was very minor and hard to see if you were not lookin for it.
