View Single Post
  #11  
Old 06-27-2022, 04:46 PM
Premslinglud Premslinglud is offline
Member
 
Join Date: May 2021
Posts: 46
Default Re: how to approach bearing edge crack on Radioking

I did some squeezing of the shell using two sets of bar clamps with 2x4s on each side. by turning the shell between the parallel 2x4, you can find the high spots. Got it to so a standard G2 head can be be put on with reasonable effort. Likely the extra wide heads would go on well at this point. Tempted to keep straightening. I don't have the extra wide in hand.
Reply With Quote