I already covered it in another post, but to sum up:
Someone at some point had already started to drill holes to mount a knobby unit on my rogers kick drum. They only drilled two holes. I'd like to drill the other two holes to have it mounted properly.
I've never drilled in to a shell before. The wrap is there and in tact, so I'll have to drill through that as well.
Could anyone give me an idea on how to do this? What kind of drill bit, how large, what pitfalls to look out for, etc?
I've heard I should tape the area to protect the wrap. Is painters tape OK? Is one peice of tape good, or should I layer it?
Any and all advice would be greatly appreciated. I'd like to get as much information as possible before I attempt this.
Thanks!!
-Pepe