Anything special I should consider when removiing a wood veneer from a floor tom that I want to rewrap? Are there any issues I should be concerned about as disctinct from removing an old wrap from a shell?
Any insights appreciated.
Lee
Anything special I should consider when removiing a wood veneer from a floor tom that I want to rewrap? Are there any issues I should be concerned about as disctinct from removing an old wrap from a shell?
Any insights appreciated.
Lee
is the veneer not factory applied?
I believe the veneer is factory applied. But I am piecing together a kit from various sources and want to rewrap all the drums. I just wasn't sure if there were specific issues related to the adhesives used on veneers, or some concern that removing a veneer was more likely to cause problems with damaging the shell, etc.
Lee
If its factory appied veneer you should just strip the finish off down to bare wood. Just make sure the thickness of the new wrap will not cause problems with heads fitting.
Thanks.
Lee
Are you sure you want to delete this post?
Are you sure you want to report this thread?