Hello,
I would like to secure this wrap that is lifting on each end of a 16x16 floor tom. I have read a number of the older posts and just want to get some advice before I start. I should say that I'm am not a craftsman by any stretch of the imagination and will be lucky if I don't permanently glue my fingers together.
I have purchased a small bottle of DAP contact cement. I couldn't find any water based.
Will I need to seperate the wraps even more to make sure I get enough cement underneath the wrap? Or would one recommend leaving the wrap as it is and using a small brush to apply cement to both sides?
Any advice is appreciated. I will add that this drum has already been re-wrapped so we are not dealing with an original Ludwig wrap.
thanks.