Ok Guys,
You asked for it and here it is. I videoed installing a drum badge grommet with a 3/8" Drive Impact Wrench. Enjoy!!!Walking
[ame]http://www.youtube.com/watch?v=2QA8SaYZPiA[/ame]
Ok Guys,
You asked for it and here it is. I videoed installing a drum badge grommet with a 3/8" Drive Impact Wrench. Enjoy!!!Walking
[ame]http://www.youtube.com/watch?v=2QA8SaYZPiA[/ame]
Educational and entertaining at the same time......
Thanks, Poppy, that sure looked easier than the last one I did.....wow...!!!
I had problems with the badge spinning... now I know what to do.
:)
Thanks Poppy for shedding light on this subject...I'm sure this will assist many members in the future including myself!
Cheers
Well done sir!!!
Great Job Poppy.
Two fat nuts.Laughing H
Awesome! Thanks Poppy.
I'm Impressed! It looks factory!Clapping Happy2
[FONT="Comic Sans MS"]Thanks Poppy. That's a valuable skill for all to have. I like the wrench on the outside technique. I have acheived the same effect to keep the badge from spinning by just putting some scotch tape on the outside of the badge, just temp taping it to shell, but have only used that approach for manual tightening..[/FONT]
Are you sure you want to delete this post?
Are you sure you want to report this thread?