Posts
Yer Forcing Me…
I have sent two emails - so far, no response. Maybe only reads emails on Saturdays??
3 years agoYer Forcing Me…
I don’t need another set of drums, but this just seems too good to pass up… https://spokane.craigslist.org/msg/d/valleyford-slingerland-drum-set/74553...
3 years agoLudwig Combo Vistalite?
Mike, Those are great! Love the Dr. Seuss-inspired cymbal holders on the outdoor photo. Josh
3 years agoAre They Vintage?
Thanks, Mark!
3 years agoAre They Vintage?
Wow! Quite complimentary! Thank you so much.
3 years agoAre They Vintage?
I bought some screw-on vent grommets to put on all of the converted toms. Instead of trying to get them each exactly centered, I just centered them u...
3 years agoPlease help to identify this Slingerland snare drum
I had a Slingerland snare from that era and it was single ply. Are you sure yours isn’t? It really cracked and was higher pitched than most ot...
3 years agoAre They Vintage?
I got the Slingerland lugs, and guess what? They, too, are too short to cover up the existing holes! There went my plan to place the four non-confor...
3 years agoAre They Vintage?
Already measured them out. If I used one current hole for mounting, the other hole would be visible below the lug. I am not averse to drilling new h...
3 years agoAre They Vintage?
Thanks, everyone. So far, the 12 and 14 sound pretty good. The 10 is only 6 1/2” deep, so I will have to offset the lugs. I hope it has enoug...
3 years agoWTB: Yamaha Lugs
Looking to buy Yamaha lugs like the one pictured. I need four of them, complete with mounting screws, washers and inserts, ideally. They are about 2...
3 years agoAre They Vintage?
[QUOTE[/QUOTE] Mark, I couldn’t find any new ones, even from Yamaha. I took them off of the 15 and 16. I am still four short for doing the 10...
3 years agoAre They Vintage?
Here are the finished products, at least the 14 and the 12. Still waiting on the hoop for the 10.
3 years agoAre They Vintage?
Next, I laid out the new lug holes on blue tape instead of the shell wrap. Using a right-angle straight edge, I laid out the location of the line of...
3 years agoAre They Vintage?
The original bearing edges were pretty complex. The slope toward the inside of the drum is about 35 degrees. I do not have, and couldn't find locall...
3 years ago